The latest evolution of the Maggi Double Line Boring Machine is now available. A thoroughly redesigned machine that improves accuracy and dramatically reduces the lenght of the working cycle thanks to the front movement of both heads, a new drilling depth side adjustment system and the new pneumatic reference pin. Features:     Double-head 46 spindles boring machine with front end adjustment Pneumatic reference Pin Side depth counter system High-quality end products Quick and precise set-up Dust collection hook-ups Patented Safety devices Extractable 400mm long support rollers on both sides for long panels 46 quick change chucks and 10" fence

 

	Side depth adjustment System
			Programming and adjusting the drilling depth is now even faster with the 2 counters positioned on the side of the heads. With the allowed use of bits of the following lengths: 57,5 - 70 - 77, the full length range necessary for any type of operation is covered. This reference system, easy and innovative, allows a quick and exact setup of boring depth with the following operations: choose the type of drill bit Cross-reference boring depth on the provided depth scale on the side of the machine turn the depth counter on each head until it shows the required depth

	Pneumatic Stop Reference Pin
			A quick, effortless, indexing system for quick execution of sequential line bores.

 

	Front movement of the 2 heads
			Easy and quick adjustment of the distance from the fence and width between the 2 heads from the front-end of the machine. Accurate reading of the distance on 2 digital counters.

 

	Long Fence & Rollers
			10 feet Long Fence with 4 tilting stops. Extractable 400mm ling support rollers on both sides.

 

	Patented Safety Clamps
			Our Safety Clamps have been studied to prevent the crushing of the operator's hand. Our clamps allow a prompt setting on panel of any dimension without any adjustment just pulling up the front hand grip. 6 Clamps standard Clamp diameter is 60 mm Clamp pressure is Kg. 90 at 6 atm each The machine has got a THRUST METER, a safety device ensuring the minimum work pressure. The maximum height of the clamp from the table is 80 mm.

	Parallel Heads with 23 spindles each
			Maximum width between heads: 25 19/32" Mimimum width between heads: 5"

 

	Electric Panel
			In compliance with CE safety requirements: no voltage release, magnetic switch proctecting the motor, low voltage switchers (24V), emergency release. Separate knobs for setting up the boring heads upwards speed.
			Reference fence 704mm for quick adjustment of the tilting stops (optional).

 

Technical Data # of Vertical Head Units 2 # of Spindles Each Head Unit (11 left red/12 right black) 23 Distance between spindle centers 32 mm. Distance between the first and last spindle center of each head 27 23/32" Max. boring depth 4" Max. height of clamps from working table 3 5/32" Inside diameter of quick change bush 10 mm Min. distance between the 2 heads 5" Max. distance between the 2 heads 25 19/32" Max. dimensions of working piece 27 18/32" x 118" Height of working table 33 1/2" # of clamps 6 # of motors 2 Motor power 2 (1,5)HP KW Motor rpm 2800 Working air pressure 6-7 bar (94 psi) Net weight 860 lbs.

Dimensions