TS29 Shaper, 7-1/2HP 3PH 230/460V with Sliding Table
Stock Number: 1791284

The new TS29 Tilt/Slide Shaper is ready to tackle any job. A new fence design includes dual digital readouts, micrometer adjustments and independently adjustable fence halves for fast, accurate set-ups. The full guard includes two stock hold-downs and a see-through cover that flips up for quick tool changes. Dual dust collection ports, in the guard and under the table insure a clear work area and improved finish. An extra large quill assembly with a full seven inch stroke has three oversize bearings and the ability to tilt, adding versatility and insuring long, trouble-free performance. Powered by a big 7-1/2HP motor that drives the spindle forward and reverse with five speeds. The massive sliding table is fully supported by six tapered precision bearings through a full four-foot stroke. In addition, on board the table is a large miter head complete with stock hold-down clamp and a 56" miter fence with flip stop. The large table can easily accommodate a stock feeder for longer production runs.

Details

• Sliding table with 4-foot stroke works with miter head, hold-down and fence to accomodate everything from multiple end cuts to tenons
• Fully adjustable fence with dual digital readout for fast, accurate set-up and repeatability
• Large table with built-in slider with room for stock feeder
• 7" vertical spindle travel allows stacked tooling
• Spindle tilts negative 5° to positive 45° for increased versatility
• Large diameter multiple table inserts accomodate virtually any size cutter
• Five spindle speeds in forward and reverse with lighted indicator

• Part Number 1791284
• Spindle Speed 3000, 4000, 6000, 8000 and 10,000 RPM
• Reversable Yes
• Spindle Diameter 3/4, 1 and 1 1/4 "
• Spindle Size Under Nut 3/4 (3 1/2), 1 (6 1/4) and 1 1/4 (6 1/4) "
• Spindle Travel 7
• Tilting Spindle 45° forward, 5° back
• Table Size 51 1/2 x 33 1/2 "
• Fence Size (L x H) 46 x 5 "
• Fence Travel (Major and Minor) 5 3/8 and 3 5/8 "
• Slide Table Size (L x W) 11 1/4 x 51 1/4 "
• Table Travel 49 1/4 "
• Table Inserts one tilting, two straight
• Maximum Diameter Cutter Below Table 9 "
• Maximum Diameter Cutter Above Table 12 "
• Router Bit Collet Diameter 1/4 and 1/2 "
• Dust Port Outside Diameter 5 " (dual ports)
• Dust Collection Minimum CFM Required 800 cu.ft/min
• Electrical Controls - Magnetic Starter Yes
• Motor Power 7½ HP
• Motor Voltage 230 / 460 V
• Prewired Voltage 230 V
• Motor Phase 3 Ph
• Model Number TS29
• Brand Powermatic
• Overall Dimensions 51 x 44 x 53
• Height 53 inch
• Width 44 inch
• Length 51 inch
• Net Weight 1100 pound