TECHNICAL SPECIFICATIONS

• Min/max width finished stock: 8-230mm / 0.31" to 9"
• Min/max height finished stoc:k 6-125mm / 0.24" to 5"
• Minimum stock length: 250mm / 9-7/8"
• Electronically controlled feed speed : 5-35m/min / 16-115 fpm
• Spindle diameter: 1-13/16"
• Maximum cutting circle of 1st horizontal bottom spindle: 180 mm / 7.08"
• Maximum cutting circle of the 2nd, 3rd, 4th, 5th and 6th spindle: 200mm / 8"
• Feed roll diameter: 140mm / 5.5"
• Adjustable in-feed table and fence: 2.000 mm / 78"
• Spindle speed: 7200 RPM

• Heavy one piece cast iron frame for optimum stability and vibration control
• Easily exchangeable bed plates
• Chromed bed plates and fences, entire machine
• Automatic lubrication on feed table for smooth feeding of stock
• Heavy upper beam supported on two wide spaced columns for extra stability and minimal vibration of the feed system

• Powered vertical positioning of upper beam through dual heavy duty gear boxes, raise and lower feed rolls includes safety switches to limit movement. Pneumatic clutch allows movement of top spindles in conjunction with feed rolls if needed.
• Adjustable pneumatic pressure on feed rolls for enhanced control
• Cardan driven feed rolls insure smooth and positive traction throughout the machine
• Heavy duty top and bottom hardened and chrome flashed feed rolls
• Top in-feed rolls are specially serrated for high traction and low penetration on stock
• Top out-feed rolls (after first top spindle) heavy duty smooth surface polyurethane
• 3 powered bed rolls located at in-feed, center and out-feed of machine
• Additional roller in front of first vertical head for enhanced control of short pieces ( extra top feed-roll device )

• High precision spindles (7200 RPM) hardened and ground turning in precision bearings insure high cutting accuracy and consistency.
• Sealed spindle housings insure permanent lubrication, minimizing maintenance and down time
• All spindles are adjusted vertically and horizontally from the front side of the machine
• Horizontal spindles equipped with pneumatic brakes to lock axial movement. Allows easy and fast axial adjustments from the front of machine without opening access door. Except 1st bottom spindle.
• All spindles have precision digital readouts for horizontal and vertical position (0.1mm, 0.004")
• Left spindle and 2nd top spindle are equipped standard with dual readouts for tool diameter compensation (0.1mm, 0.004")
• Two segmented air-loaded horizontal chip breakers on each top head

• Machine mounted environmental enclosure. Interlocked single lift-up door with gas springs allows easy access to machine
• Centralized lubrication system minimizes routine maintenance and prevents oversights
• Thermal overload interlocked circuit breakers
• Main Power 3/60/460V

• 1st bottom horizontal spindle: 10 HP
• Right vertical spindle: 10 HP
• Left vertical spindle: 10 HP
• 1st top horizontal spindle: 20 HP
• 2nd Top horizontal spindle: 20 HP
• 2nd Bottom horizontal spindle : 15 HP
• Feed motor : 5.5 HP
• Beam adjustment : 2.0 HP