Features:

• Adjustable hold-down clamp and boing head are pneumatically controlled by a foot pedal to operator's hands free. See-through guard protects from flying wood chips.
• Loosening the nut just below the boring head allows for operator to quickly adjust the depth stop for final drilling depth. Guide rails are concealed inside flexible rubber tubing for protection against dust and chips.
• Tough cast iron table is mounted on dovetail ways with an adjustable gib. The four bolts located on the right-hand side may be adjusted to compensate for wear.
• Aluminum Boring Head contains two adjustable spindles. Easy-to-read scale and reference lines for accurate setting. Convenient grease fitting accepts standard grease gun for lubricating boring head.
• Heavy cast iron table features dovetailed miter gage slots for keeping miter gage secured when locked in place. Also with standard-equipped stock stop for operations that require repetitive drilling.
• Built-in chip chute directs dust and debris away from machine.
• Cast iron carriage supports motor and boring head.
• Adjustable feed rate knob controls boring speed at which the drill bits enter the workpiece.
• Fabricated steel cabinter has bolt-down feet for operating stability.

 
SPECIFICATIONS

Motor :

• Motor - 1 HP, 3450 rpm, 115/230V, 60 Hz., single phase

• Table Size - 15-3/4" x 9-7/8" (400 x 251 mm)

• Length - 37-1/2" (953 mm)
  Width - 15-3/4" (400 mm)
  Height - 48" (1219 mm)

• Weight - 303 lbs. (137 kg)

• Spindle - Accepts 7/16" - 14 RH TPI

• Maximum Bit Diameter w/Spindles at 3/4" on Center - 5/8" (15 mm)

• Drill Stroke (Carriage Stroke) - 3-7/8" (98 mm)

• Max/Min Center Distance of Spindle - 3/4" to 3" (19 to 76 mm)

• Air Requirement - 90 PSI

• Table Travel to Center of Bit - 3-1/2" (89 mm)

• Maximum Material Thickness - (Table to Guard) 8-1/2" (216 mm)